How do I connect a Canon MG3050 printer to Wi-Fi?


Want to know how to connect your Canon MG3050 to Wi-Fi? In this case, read the instructions below. Here's everything you need to know about connecting your Canon printer to a wireless network.


There are two ways to connect. One is the WPS connection method and the other is the default connection method. In this post, you will learn how to do this with a WPS connection.

How do I connect a Canon MG3050 printer to Wi-Fi?


Uses Canon WPS connection method


Before proceeding, connect the Canon MG3050 to a wireless network using the WPS key.


There are some conditions you must meet.


  • Your router device should have a virtual WPS button. To do this, read the operating instructions supplied with the device.


  • You need to make sure your network uses secure Wi-Fi or WPA2 access. Most WPS-enabled routers cannot connect to WPS if they use the WEP security method. If you want to know how to work safely over Wi-Fi, you need to check your computer's Wi-Fi settings. 


Follow the steps below to connect your Canon MG3050 to Wi-Fi


Step 1: Make sure your wireless router is stored next to the printer and you are ready to press the WPS button.


Step 2: Then press the WPS button on the printer. Press the button until you see the wireless light turn on.

Step 3: Press the C button, the color button.

Step 4: Press the wireless button and wait until the right light flashes. 

Step 5. Click the colors button and then make sure the light is on. Also, check that the wave light is pulsating. Then press the WPS button on the router for 2 minutes.


If you need accurate information on how to press a WPS button, read the router instructions carefully.


 Verify network settings


You can print printer network settings to make sure your printer is properly connected to the wireless network.


Step 1: Make sure the printer is turned on.


Step 2: Insert plain paper or A-4 sheets into your printer.


Step 3: Press and hold the Wi-Fi button and wait for the indicator 

             to flash.

Step 4: Then press the color button. 


Step 5: Now press the Wi-Fi button twice.


Step 6: Then press the black or colored button.


When prompted to print, make sure the active signal is indicated by a link. Also, make sure that the SSD shows the correct name for your network.